Lcd Backlight Hold - Midland BASE TECH III Operator's Manual

18) LCD back light hold
By Default, back light illuminates for 5 seconds after any key press then goes out. Press SHIFT +1
for back light hold. Press SHIFT+ 1 again to be back normal. Figure-below shows back light turns
on.
19) Changing TX power
Press SHIFT+2 to select High and Low TX power.
programmed Hi-Lo power with programming soft, SHIFT+2 overcomes this pre-program level.
Figure-below shows Hi power with SHIFT+2.
20) Caller ID
BASE TECH III indicates caller's Unit ID or Individual ID. However if the radio is programmed as
repeater mode, these caller's ID are not displayed. Figure-below shows caller's ID 12345.
RX
TX
C001 Channel
GP Light turn ON
RX
TX
C001 Channel
GP 500
RX
TX
C001 Channel
Call 0 0 1 2 3 4 5
Base Tech III Operating Manual
12
shows high power. If the radios are pre-