Table of Contents
Advertisement
Height Adjustment Stand
To unlock the height adjustment feature of the stand, locate the pin
on the back of the stand column and turn the pin knob
counter-clockwise. (See fig.1-1 )
Tilt, Swivel and Pivot Rotation
The LCD Monitor is designed to have a tilt range of -5°to
+25°, a swivel range of -35°to +35°, and a 90° pivot
rotation. (See fig. 1-2)
Warning: Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this
will result in damaging the Monitor and Monitor stand. The monitor stand base may forcefully extend and cause
injury. Raise the monitor to its "Full Up" position before removing the monitor stand.
Optional Mounting Alternatives
Warning: The monitor stand base may forcefully extend and cause injury. Raise the monitor to its "Full Up"
position before removing the monitor stand.
Optional Mounting Alternatives
Warning:
The monitor stand base may forcefully extend and cause
injury. Raise the monitor to its "Full Up" position before removing
the monitor stand.
Detaching LCD Monitor from Its Stand
Unscrew screws
down
the second.
Interface for Arm Applications
Before installing to mounting device, please refer to Fig.1-3.
The rear of this LCD display has four integrated 4 mm, 0.7 pitches
threaded nuts, as well as four 5 mm access holes in the plastic
covering as illustrated in Figure 1-4. These specifications meet the
VESA Flat Panel Monitor Physical Mounting Interface
Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13
November 1997).
Note :Please using Ø 4mm x 8mm (L) screw for this application.
the swivel base support column and pull
5
Figure 1-1
Figure 1-2
Figure 1-3
Figure 1-4
Advertisement
Table of Contents
