If the product has been dropped or the casting is broken. If there is a dramatic change of the performance. A proper type of power cord has been selected according to the safety of destination and must be used to prevent electric shock. Model No.: PL190M...
Getting Started Congratulations on your purchase of this TFT LCD Monitor. Please read this section carefully to get instant understanding of this product and its correct operations. Important! Please keep the original carton and all packing materials for future shipping needs. Package Contents Your TFT LCD Monitor package includes the following items: 19.0”...
Precautions Sit at least 18"(45 cm) away from the screen when in use. Do not press on the LCD panel as it is very fragile. Do not touch the LCD panel with your bare hands. Oil from your skin is difficult to remove and may damage the screen.
Adjusting the Monitor Press down on the stand and gently adjust the monitor to a suitable viewing angle (see Figure below). Please note that this monitor can only be tilted forward to 5 degree and backward to 20 degrees. To prevent damage to the monitor, do not press the screen over its tolerant angles.
Quick Installation Make sure the computer is turned off. Attach the female end of the power cord (Indication F) to the adapter (Indication E), then plug the adapter connector to the power “DC-IN (Indication A)” jack of the LCD monitor. When using a power cord, plug the male end into the wall socket.
Operations Push the power button (Indication E) on the front of the LCD monitor to turn it on. When the power light (Indication F) turns green, the LCD is ready to use. Push the power switch button to turn off. Function Keys A.
OSD Main Menu For screen adjustments, press the [Menu] button to display the OSD (On-Screen Display) Main Menu shown below. Press the [+] or [ ] button to scroll up or down the menu to your required options. Please note that the OSD will automatically turn off in 30 seconds without any manipulation or by simply pressing the [Menu] button for 2 seconds.
COLOR Sub-Menu Under the Main Menu, select COLOR using the [+] or [ ] button, then press [Menu] button to activate the COLOR Sub-Menu shown as above. Under the COLOR Sub-Menu, press [+] or [ ] button to scroll up or down to your desired preset color mode.
H–POSITION Moves the screen image to the right or left. Select H-POSITION using the [+] or [ ] button, then press the [Menu] button to activate the function. Press [+] button to move the screen to the right, [ ] button to move to the left. Press [Menu] to return to LCD ADJUST Sub-Menu.
Page 12
H-OSD POSITION Moves the OSD position on the screen to the right or left. Select H- OSD POSITION using [+] or [ ] button, then press [Menu] button to activate the function. Press the [+] button to move the OSD position to the right, [ ] button to move left. Then Press [Menu] to return to MISC Sub-Menu after adjustment.
Technical Data Specifications Size Type Color Glass surface Brightness Contrast Viewing Angle Input Signal Video Video Sync Sync Compatibility Macintosh® Resolution Primary Mode Power Voltage Connector Input Signal Display Area Full screen Operating Temperature Conditions Humidity Altitude Storage Temperature Conditions Humidity Altitude Dimensions...
Factory Preset Timings Horizontal Timing Frequency (KHz) VGA 640 X 350 31.470 VGA 720 X 400 31.467 VGA 640 X 400 31.469 VESA 640 X 480 31.469 VESA 640 X 480 37.861 VESA 640 X 480 37.500 VESA 640 X 480 35.000 VESA 800 X 600 35.156...
Appendix FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.