Installing Software; Installing The Software - JVC DLA-X770R Instructions Manual

Preparation for the Calibration Adjustment

Installing the Software

Pre-installation Check
Before starting the installation, ensure that no program is running.
During installation or calibration, set the PC to the administrator mode, and disable the screen mode and energy-
saving mode of the PC.
Do not connect the optical sensor to the PC before installing the driver.

Installing Software

Double-click the download file "JVC_PJ_Calibration9_en_v***.zip" to start installation. Download the file to a
directory, and unzip the file.
The following file is created.
● "JVC_PJ_Calibration9_v***.msi"
Double-click "JVC_PJ_Calibration9_v***.msi" to start installation.
1
"Welcome to the JVC Projector Calibration Software Setup Wizard" window appears. Click the [Next] button.
2
"Select installation Folder" window appears. You can proceed to the next step with the destination unchanged,
or designate a folder if necessary.
3
"Confirm installation" window appears. Click the [Next] button.
4
After installation is complete, an "Installation complete" window appears. Click the [Close] button to exit the
wizard. Check to ensure that short-cut icons are automatically created both in the Start menu and on the
Desktop.
Caution
* This software does not run on its own. To run the program, you need to connect the optical sensor to a PC via USB
cable, and the PC to a projector via LAN cable.
Installing the Optical Sensor Driver
Install the driver of the optical sensor to be used.
Do not run the software supplied with the optical sensor when using this calibration software.
3