To View Stored Video and Picture To Delete File Flying Control Heading Hold Mode Altitude Hold Mode High / Medium / Low Speed Mode Replacement of Propeller and Motor U842-2 Recording Video and Taking Photo Spare Parts Exploded View Troubleshooting Guide...
Notice: (3) Safe operation Please operate the RC drone in accordance with your physical 1. Important Statement: status and flying skill. Fatigue, listlessness and improper operation may increase the rate of accident. (1) This product is not a ordinary toy but a piece of complicated equipment which is integrated with professional knowledge by (4) Keep away from rotating parts mechanic, electronic, air mechanics, high-frequency emission etc.,...
Main Specification 2. Transmitter Rotate Down the Drone Size 485*485*150mm Max Flying Distance/Radius 100m Rotate Up the Camera Camera Max Image Transmission Rigiht Stick Drone Weight 380g Distance/Radius (Forward / Backward / Left Stick Propeller Diameter 190mm Camera Resolution 1280x720P Left / Right Flying Stick / (Throttle / Rotation Altitude Hold Mode)
Propeller Guard Installation Diagram 3. Plug the camera cable to the camera port and plug the camera gimbal cable to the camera gimbal port. 1.7*6PB Screws Camera Port Camera Gimbal Port Flying Preparation 1. To install the propeller guard, to the drone and make sure the propeller 1.
3. Tips for Battery 3. Connect the battery plug and the drone plug. * Power off the drone first when finished flying and then take out the battery. * Charge the battery after the battery surface cooling down. * Keep away from heat and put the battery in dry place when the battery is not being used for a long time.
6. To calibrate. Place the drone on a flat surface on the horizontal position. Keep the Left Stick on the lowest position and push the Right Stick to bottom Press “PAIR” Button right as below picture shown. The drone drone body lights flash rapidly PAIR EXIT and the drone is calibrating.
To Take Picture To View Stored Video and Picture 2. “JPG” Icon White SD Card Icon View Button VIEW SNAP Insert the SD card to DOWN card slot VIEW 1. SNAP Button SNAP DOWN Take out the SD card from the camera and insert it to the card slot in the right side of the display screen.
Flying Control 4. To fly Forward and Backward 1. To fly up and down Push the Right Stick up to fly the drone forward and pull the Right Stick down to fly the drone backward. 5. If the drone rotates to the left or right Push the Left Stick up to fly the drone up, and pull the Left Stick down to fly the drone down.
Heading Hold Mode Altitude Hold Mode Altitude hold mode indicates that the drone maintains a consistent altitude Drones generally have a front and rear indicated by LED lights or colored when flying. It makes it easier to control the drone for beginner and more Propellers.
Replacement of Propeller and Motor Notice: 1. The Altitude Hold Mode is available only when the Throttle (Left Stick) more than 1. Replacement of Propeller 40%. The drone will exit from Altitude Hold Mode automatically if you pull the Left Stick to the lowest position. Please use the attached new propellers to replace the damaged propeller.
Notice: Press Video Recording button to save a video when finishing recording to save the video. When the drone in low battery, press the button immediately or the video can not be saved. U842-2-01 U842-2-02 U842-2-03 U842-2-04...
Exploded View Troubleshooting Guide Problem Problem Cause Solution 1. The transmitter battery is too low. 1. Replace battery. 2. The battery positive pole and negative 2. Install the battery in accordance with the transmitter pole are in reverse order. user manual. indicator light is off 3.