Table of Contents
Advertisement
G.722 Advertisement
Cisco Unified Communications Manager versions 5.0 and later support the ability to configure whether G.722 is to be a
supported codec system wide or not.
Earlier versions of Cisco Unified Communications Manager do not have this capability, where a Cisco Unified Wireless IP
Phone 7925G Series will attempt to use G.722 assuming the other endpoint also advertises G.722 capabilities.
If using a version of Cisco Unified Communications Manager prior to 5.0 and want to disable G.722 capabilities, then the latest
device package will need to be applied to the Cisco Unified Communications Manager to enable this product specific
configuration option for each Cisco Unified Wireless IP Phone 7925G Series.
For more information, refer to the Cisco Unified Communications Manager documentation.
http://www.cisco.com/en/US/products/sw/voicesw/ps556/tsd_products_support_series_home.html
Product Specific Configuration Options
On the IP Phone Configuration page in Cisco Unified Communications Manager Administration, the following Cisco Unified
Wireless IP Phone 7925G Series configuration options are available.
For an explanation of these options, click the "?" on the configuration page.
Product specific configuration options can be configured in bulk via the Bulk Admin Tool if using Cisco Unified
Communications Manager 5.0 and later. If using a prior version, then must be configured separately.
As of the 1.4(1) release Multiple Level Vendor Configuration is allowed to override common settings.
Some of the product specific configuration options can be configured on an enterprise phone, common phone profile or
individual phone configuration level.
Cisco Unified Wireless IP Phone 7925G Series Deployment Guide
45
Advertisement
Table of Contents
