Sony VTX-D800U Service Manual page 9

31 Slot 0 bypass
32 Slot 0 pass thru
33 Slot 1 bypass
34 Slot 1 pass thru
35
36
37
38
39
Software upgrade
41 Upgrade Serial
42 Upgrade Ethernet
43 Upgrade off-air
44 Upgrade Memory
stick
45
46
47
48
49 Allow downgrade
Screen control
51
52
53
54
55
56
57
58
59
I/O
61 LED OFF
Service Manual
Transport stream is set to bypass slot 0.
This command is effective only when there is no CAM
inserted into slot 0.
Transport stream is set to pass out/in slot 0.
This command is effective only when there is no DVB
compliant CAM inserted into slot 0.
If there is no output/input device then the demux will
not receive a valid transport stream.
Transport stream is set to bypass slot 1.
This command is effective only when there is no CAM
inserted into slot 1.
Transport stream is set to pass out/in slot 1.
This command is effective only when there is no DVB
compliant CAM inserted into slot 1.
If there is no output/input device then the demux will
not receive a valid transport stream.
Forces a software upgrade from the serial port
STB will reset after loading & TT mode will be
cancelled
Forces a software upgrade from the Ethernet port (if
available)
STB will reset after loading & TT mode will be
cancelled
Forces a software upgrade from the current service
A change of service, satellite, etc will be done as
required.
STB will reset after loading & TT mode will be
cancelled
Forces a software upgrade from the Memory stick (if
available)
STB will reset after loading & TT mode will be
cancelled
On next SW update, update the software even if the
version is older than, or the same as, the current
version
Sets all LED's Off
- 9 -
Yes
Yes No
Yes
Yes
Yes