Replacing The Logo - Electro-Voice EVID-S10.1DW Installation Manual

EVID-S Surface Mount Dual 10" Subwoofers
5.
6.
7.
8.
See also
•
4.2

Replacing the logo

An additional logo is included, vertical installation is shown.
To replace the logo, do the following:
1.
2.
3.
2017.08 | 01 | F.01U.345.359
Install four 8-mm rated forged eyebolts (not included) into the threaded fly points.
Install an 8-mm rated forged eyebolt (not included) into the safety point.
Suspend the subwoofer from the eyebolts using rated fittings and steel cable.
Secure the subwoofer from the safety eyebolt using rated fittings and steel cable.
Replacing the logo, page 10
Remove the existing logo.
Clean the surface with alcohol.
Remove the paper backing.
Installation manual Electro-Voice