Other Problems When Using The Auto Mcacc Setup; Better Sound Using Phase Control - Pioneer VSX-818V-K Operating Instructions Manual

02 5 minute guide
You can also choose to view the settings by
selecting individual parameters from the
Analyzed Data Check screen:
• Speaker Setting – The size and number of
speakers you've connected (see page 42
for more on this)
• Speaker Distance – The distance of your
speakers from the listening position (see
page 45 for more on this)
• Channel Level – The overall balance of
your speaker system (see page 44 for more
on this)
• Acoustic Cal EQ – Adjustments to the
frequency balance of your speaker system
based on the acoustic characteristics of
your room (see page 40 for more on this)
Press RETURN after you have finished
checking each screen. When you're finished,
select SKIP to go back to the System Setup
menu.
Other problems when using the Auto
MCACC Setup
If the room environment is not optimal for the
Auto MCACC Setup (too much background
noise, echo off the walls, obstacles blocking
the speakers from the microphone) the final
settings may be incorrect. Check for household
appliances (air conditioner, fridge, fan, etc.),
that may be affecting the environment and
switch them off if necessary. If there are any
instructions showing in the front panel display,
please follow them.
• Some older TVs may interfere with the
operation of the microphone. If this seems
to be happening, switch off the TV when
doing the Auto MCACC Setup.
Note
1 Phase matching is a very important factor in achieving proper sound reproduction. If two waveforms are 'in phase', they crest
and trough together, resulting in increased amplitude, clarity and presence of the sound signal. If a crest of a wave meets a
trough (as shown in the upper section of the diagram above) then the sound will be 'out of phase' and an unreliable sound
image will be produced.
10
En
Better sound using Phase
Control
This receiver's Phase Control feature uses
phase correction measures to make sure your
sound source arrives at the listening position
in phase, preventing unwanted distortion and/
or coloring of the sound (see illustration
below).
P
Front speaker
H
A
S
E
C
O
N
T
R
O
L
Sound
O source Subwoofer
F
F
Front speaker
P
H
A
S
E
C
O
N
T
R
O
Sound
L
source Subwoofer
O
N
Phase Control technology provides coherent
sound reproduction through the use of phase
1
matching for an optimal sound image at your
listening position. The default setting is on and
we recommend leaving Phase Control
switched on for all sound sources.
STEREO/
AUTO/DIRECT
A.L.C.
ACOUSTIC
PHASE EQ
• Press PHASE (PHASE CONTROL) to switch
on phase correction.
Listening
position
?
Listening
position
STANDARD ADV SURR
SOUND
DIALOG RETRIEVER