Table of Contents
Advertisement
3
3
7
Wait for the test tones to finish.
A progress report is displayed on-screen while the
receiver outputs test tones to determine the speakers
present in your setup. Try to be as quiet as possible while
it's doing this.
1 . Aut o MCACC
Now Ana lyzin g
Environ men t Check
Am bien t No is e
Sp eaker YES/NO
Ret ur n
•
For correct speaker settings, do not adjust the volume
during the test tones.
8
Confirm the speaker configuration.
The configuration shown on-screen should reflect the
actual speakers you have.
1 . Auto MCACC
Check!
Front
[ YES ]
Center
[ YES ]
[ YES ]
Surr
Surr. Back
[
--- ]
Subwoofer
[ YES ]
OK
10:Next
Return
•
With error messages (such as Too much ambient
noise) select RETRY after checking for ambient noise
(see
Other problems when using the Auto MCACC
setup
below).
If the speaker configuration displayed isn't correct, use
/
to select the speaker and
/
setting. When you're finished, go to the next step.
If you see an error message (ERR) in the right side
column, there may be a problem with the speaker
connection. If selecting RETRY doesn't fix the problem,
turn off the power and check the speaker connections.
9
Make sure 'OK' is selected, then press ENTER.
If the screen in step 8 is left untouched for 10 seconds
and
is not pressed in step 9, the Auto MCACC
ENTER
setup will start automatically as shown.
A progress report is displayed on-screen while the
receiver outputs more test tones to determine the
optimum receiver settings for channel level, speaker
distance, and Acoustic Calibration EQ.
Again, try to be as quiet as possible while this is
happening. It may take 1 to 3 minutes.
10
The Auto MCACC setup has finished! You return to the
Home Menu.
The settings made in the Auto MCACC setup should give
you excellent surround sound from your system, but it is
also possible to adjust these settings manually using the
Home Menu (starting on
Note
•
Depending on the characteristics of your room, sometimes
identical speakers with cone sizes of around 12 cm
(5 inches) will end up with different size settings. You can
correct the setting manually using the
page
46.
•
The subwoofer distance setting may be farther than the
to change the
actual distance from the listening position. This setting
should be accurate (taking delay and room characteristics
into account) and generally does not need to be changed.
1 . Auto MC ACC
Now A na ly z in g
S urrou nd An a lyz i ng
S pe a k e r S y s te m
S pe a k e r D i s ta nc e
Ch a nne l L ev e l
Ac o us ti c C a l E Q
Re tu rn
page
46).
Speaker Setting on
24
Other problems when using the Auto MCACC
setup
If the room environment is not optimal for the Auto MCACC
setup (too much background noise, echo off the walls,
obstacles blocking the speakers from the microphone) the
final settings may be incorrect. Check for household
appliances (air conditioner, fridge, fan, etc.), that may be
affecting the environment and switch them off if necessary. If
there are any instructions showing in the front panel display,
please follow them.
•
Some older TVs may interfere with the operation of the
microphone. If this seems to be happening, switch off the
TV when doing the Auto MCACC setup.
Basic Setup
Advertisement
Table of Contents
