Hitachi C 7WDM Safety And Instruction Manual page 22

English
AFTER CONNECTING THE POWER PLUG TO AN APPROPRIATE AC
POWER SOURCE, CHECK THE OPERATION OF THE TOOL AS FOLLOWS:
12. Trial run
After confi rming that no one is standing behind, the power tool start and confi rm that no
operating abnormalities exist before attempting a cutting operation.
13. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for defl ection to confi rm that the blade
is not noticeably unstable; otherwise vibrations might occur and cause an accident.
14. Prepare a wooden workbench (Fig. 15)
Since the saw blade will extend beyond the lower surface of the workpiece, place the
workpiece on a workbench when cutting. If a square block is utilized as a workbench,
select level ground to ensure it is properly stabilized. An unstable workbench will result in
hazardous operation.
CAUTION:
To avoid possible accident, always ensure that the portion of workpiece remaining after
cutting is securely anchored or held in position.
22
Workpiece
Saw blade
Workbench
Fig. 15
Base