Lenovo ThinkServer TS150 Operating System Installation Manual page 40

To create a swap partition, do the following:
a. In the Expert Partitioner window, select Hard Disks, and then click Add.
b. In the New Partitions Type, select Primary Partition.
c. In the New Partitions Size window, select Custom Size.
d. Type the amount of space (in MB) in the Custom Size field.
e. In the Formatting Options area, select Swap from the File system drop-down list box.
f. In the Mount partition area, select Swap from the Mount Point drop-down list box.
g. Click Finish.
Go to the Expert Partitioner window. The created root partition, boot partition, or swap partition is
displayed in the window. Ensure that the created partition is correct and click Accept. The drive
partition is finished.
9. In the Installation Settings window, click Software to select your desired software programs, and then
click OK. If the YaST window is displayed, click Accept.
10. Click Install to install the software programs that you have selected.
Notes:
• If a Warning window is displayed, select the option you desired. The following steps are based on the
scenario that Ignore this conflict of ... is selected. Do the following:
a. Click OK-TryAgain.
b. In the YaST window, click Accept.
c. In the Installation Settings window, click Install to begin the installation.
• If the YaST2 window is displayed, click Install to begin the installation.
11. When the Confirm Installation window is displayed, click Install. When the installation process is
completed, the server will restart automatically.
12. The setup process continues after the server restarts. Set your root user password. Then, select Next.
When the YaST2 window is displayed, click Yes.
Note: The password is optional and must contain at least six characters and consist of upper case
letters, lower case letters, and numbers.
13. Set your host name and domain name in the Hostname and Domain Name window. Then click Next.
14. Configure your network in the Network Configuration window. Then click Next.
Note: If the Test Internet Connection window is displayed, configure the settings you need. Then
click Next.
15. In the Network Services Configuration window, click Next.
16. In the User Authentication Method window, configure the settings you need. Then click Next.
17. In the New LDAP User window, configure the settings you need. Then click Next ➙ Yes.
18. In the Release Notes window, click Next.
19. In the Hardware Configuration window, click Next.
20. In the Installation Completed window, click Finish.
Note: If the YaST2 window is displayed, click Continue.
21. Follow the instructions on the screen to log in to the operating system.
36
ThinkServer TS150 Operating System Installation Guide