Table of Contents
Advertisement
3.1
Main body (Used figure are KD-ADV5580J)
3.1.1 Removing the Bottom chassis (See Fig.1)
(1) Disengage six hooks a engaged Bottom chassis.
a
hook
3.1.2 Removing the Front chassis (See Fig.2)
(1) Disengage four hooks b both side of the Front chassis.
3.1.3 Removing the Heat sink (See Fig.3)
(1) Remove the two screws A, two screws B and one screw C
attaching the Heat sink.
A
B
1-10 (No.MA437<Rev.003>)
SECTION 3
DISASSEMBLY
a
hook
Fig.1
b
hook
Fig.2
C
Fig.3
3.1.4 Removing the Main board (See Fig.4 to 6)
(1) Remove the three screws D, two screws E, two screws F
and one screw G attaching the Rear bracket. (See Fig.4)
E
F
G F
(2) Remove the three screws H attaching the Main board. (See
Fig.5)
H
(3) Disconnect the card wire from Main board connected to
connector
CN403
of the Front end board. (See Fig.6)
REFERENCE: Screw E, F and G are attaching and can take
off the main board.
D
E
Fig.4
Fig.5
CN403
Fig.6
H
Advertisement
Table of Contents
