Controlling The Rest Of Your System; Operating Multiple Receivers; Setting The Remote To Control Other Components; Selecting Preset Codes Directly - Pioneer VSX-LX52 Operating Instructions Manual

Controlling the rest of your system

Chapter 9:
Controlling the rest of your system

Operating multiple receivers

The remote control included with this receiver can be
used to operate up to three other receivers (of the same
model as this receiver) in addition to this receiver. The
receiver to be operated is switched by inputting the
preset code to set the remote control setting.
• Set the remote modes on the receivers before using
this function (see Remote Control Mode Setup on
page 90).
HDMI OUT
1 2 3
SIGNAL SEL MCACC SLEEP
4 5 6
SBch A.ATT DIMMER
7 8 9
D.ACCESS CH LEVEL CLASS
0
ENTER
1 Check the operation selector switch to MAIN.
RECEIVER
2 Press .
3 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
4 Use the number buttons to enter the 5-digit preset
code (see below).
• Receiver 1: 6 1 9 3 5 (Default)
• Receiver 2: 6 2 6 3 0
• Receiver 3: 6 2 6 3 1
• Receiver 4: 6 2 6 3 2
When the preset code is fully input, the LED flashes once
to indicate that the setting is completed.
To operate another receiver, start over from step 1 to
input its preset code.
Note
1 You can't assign , TUNER or iPod/USB.
RECEIVER
CH
AUDIO INFO
DISP
TV CTRL RECEIVER
REMOTE
SETUP
ZONE 2 ZONE 3
MAIN
Setting the remote to control other
components
Most components can be assigned to one of the input
function buttons (such as DVD or CD) using the
component's manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
Note
• You can cancel or exit any of the steps by pressing
. To go back a step, press RETURN.
RECEIVER
• After one minute of inactivity, the remote
automatically exits the operation.

Selecting preset codes directly

1 Press the input function button for the component
1
you want to control.
When assigning preset codes to TV CONTROL, press TV
CTRL here.
2 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
3 Use the number buttons to enter the 5-digit preset
code.
See Preset code list on page 105.
When the preset code is fully input, the LED flashes once
to indicate that the setting is completed.
4 Repeat steps 1 through 3 for the other components
you want to control.
To try out the remote control, switch the component on or
off (into standby) by pressing  SOURCE. If it doesn't
seem to work, select the next code from the list (if there
is one).
09
67
En