Connecting An Hdmi-Equipped Component To The Front Panel Input - Pioneer VSX-LX52 Operating Instructions Manual

Connecting your equipment
• Connect your computer to the RS-232C jack on the
rear panel of the receiver.
Make sure that the receiver and all connected
components are switched off and disconnected from the
power outlet when you do this.
Use a commercially-available cable to connect the RS-
232C jack on your computer to the 9-pin RS-232C jack on
this receiver. See the documentation provided with the
Advanced MCACC application for more information.
HDMI BD IN IN 1
ASSIGNABLE
1 3
COMPONENT
VIDEO
ASSIGNABLE
IN 1
IN 2
(DVD) (DVR) L
Y Y
R
P P
B B
ZONE2 ZONE3
OUT OUT
P P
R R
MONITOR
OUT
MONITOR
VIDEO
Y OUT
P
B
S-VIDEO
P
R
CONTROL
RS-232C IN OUT
RS-232C
Note
1 The various parameters and the reverb characteristics data used for display on the computer are not cleared when the power is turned off (see
Output PC on page 81).
1
IN 2 IN 3 OUT 1 (KURO OUT
LINK)
DVD TV/SAT VIDEO DVR
IN IN IN OUT IN
12 V TRIGGER
(OUTPUT 12 V
IR
TOTAL 50 mA MAX)
1 2
IN IN OUT
1 2
Personal computer
Connecting an HDMI-equipped
component to the front panel input
There is an HDMI input terminal on the front panel. High
quality pictures can be viewed via the receiver simply by
connecting an HDMI-equipped video camera with a
single HDMI cable. HDMI-equipped components other
than video cameras can also be connected to this
terminal.
• Push down on the PUSH OPEN tab to access the
front panel input.
• Select this input using INPUT SELECT (remote) or the
INPUT SELECTOR dial (front panel) to select HDMI 4.
CONTROL ON / OFF
VIDEO CAMERA
iPod
iPhone
MCACC SETUP MIC USB
Video camera, etc.
MASTER
VOLUME
HDMI 4
This receiver
03
35
En