Replacing A Turn Signal Light Bulb; License Plate Light - Yamaha Bolt XVS95CH Owner's Manual

Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screws.
2
1. Screw
2. Turn signal light lens
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
Periodic maintenance and adjustment
EAU24215
1
1. Turn signal light bulb
3. Insert a new bulb into the socket,
1
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
7-32

License plate light

If the license plate light does not come
on, have a Yamaha dealer check the
electrical circuit or replace the bulb.
[ECA10682]
EAU24331
7