Adjusting Bass And Treble - Pioneer VSX-D909S Operating Instructions Manual

Basic Playback

Adjusting Bass and Treble

You can use BASS +/– or TREBLE +/– buttons to adjust the low and high frequencies for each individual set of
speakers. If the receiver is in STEREO mode you can only adjust the FRONT speakers. In a surround mode
(STANDARD, ADVANCED THEATER, etc.) you can adjust the FRONT, CENTER, SURROUND and SURROUND
BACK speakers. The TONE button can also be used to bypass the tone circuitry (see p.22).
1 2
VSX-D909S Digital Signal Processor
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
STANDBY/ON
DSP
STEREO/
STANDBY MODE DIRECT
/DTS
SIGNAL SELECT ADVANCED STANDARD
MULTI CH CHANNEL
SELECT
INPUT TONE LOUDNESS
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
PHONES
SPEAKERS - BASS + - TREBLE +
3
50
1 Press the TONE button on the front panel to
MULTI-ROOM INPUT 2 Press the CHANNEL SELECT button on the
SELECTOR
&SOURCE
CONTROL
MASTER
VOLUME
DIGITAL FL
NR DIMMER CLASS BAND - TUNING +
TUNER CONTROL
VIDEO TAPE 2
SELCT MONITOR MPX MEMORY - STATION +
DOWN UP
3 Use the BASS or TREBLE (+/–) buttons to
put the receiver in tone on mode.
front panel to cycle through the different
tone adjust modes.
The button cycles though the possibilities in the following
order:
TONE Front
TONE SurBack
adjust the low or high frequencies of each
channel.
SIGNAL
SELECT
ANALOG SP A
A few seconds after you finish adjusting the tone the receiver will
revert to the sound mode it was in at the beginning of the
process.
• The tone control can be adjusted in a range of ±6 dB.
memo
• The tone control cannot be adjusted in MULTI CH IN mode.
• If the receiver is in DIRECT mode and you press the TONE
button, TONE BYPASS will appear in the display, letting you
know that you can't change the tone in DIRECT mode.
Another press cancels DIRECT mode.
TONE Center
TONE Surr.
STEREO
VOLUME
dB