Pioneer VSX-D909S Operating Instructions Manual page 36

Initial Set Up
Î
S0URCE
MULTI
OPERATION
DVD/LD TV/SAT
MULTI CONTROL
MD/
CD
TAPE1
CLASS MPX
¶ 7
- +
TUNING
1 ¡
DTV ON/OFF DTV MENU
1
4
7
GUIDE
+10
+
TV
TV VOL TV CONTROL
–
TV FUNC
REMOTE SETUP
INPUT
MENU
ATT
SYSTEM SETUP
+
EFFECT/
CH SEL
ENTER
DIGITAL
–
NR
MULTI CH
MIDNIGHT
INPUT
LIGHT
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
memo
Note that it is also possible to set
channel levels temporarily. Then follow
the same procedure as explained on
this page. This function is designed to
be used when you want to change the
levels temporarily to raise the level of
one channel. Using this method you
can set speaker levels in different
modes, such as, STEREO, and each
DSP mode, independently. You should
return the settings to their original
state when done. Doing the set up
procedures on this page will erase any
temporary/independent level settings
that have been made.
36
4 Adjust speaker levels so that you hear the
USE SETUP
RECEIVER
SYSTEM
OFF
VCR1 VCR2
TUNER TVCONT
BAND DIRECT ACCESS
3 8
- +
STATION
4 ¢
- +
CHANNEL
2 3
5 6
8 9
EXIT
0
ENTER
DISC
+
VOLUME
–
MUTE
FUNCTION
5 When you have adjusted each speaker level,
4-6
SIGNAL
SELECT
STEREO/
DSP
DIRECT
/ DTS
ADVANCED
STANDARD
6 Select EXIT with the 5/∞ buttons and press
test tone at the same volume from each
speaker when seated in your main listening
position.
Note: The volume of the subwoofer tends to sound lower than
it actually is, you may need to raise its level after testing the
sound with actual soundtracks.
In AUTO mode
1 Press the 2 or 3 button to adjust the level of the speaker
outputting the TEST TONE.
In MANUAL mode
1 Press the 2 or 3 button to adjust the level of the first
speaker.
2 Press the 5/∞ button to switch the TEST TONE to the next
speaker.
3 Repeat 1 and 2 for each speaker.
If you are using a Sound Pressure Level (SPL) meter
Take the readings from your main listening position and adjust
the level of each speaker to 75 dB SPL (C-weighted/slow
mode).
press ENTER button to return to the
previous screen.
The MASTER VOLUME will return to its original position.
ENTER button to return to the SYSTEM
SETUP MENU.
Next, proceed to CROSSOVER NETWORK on the next page.
If you want to change a setting before proceeding simply
use the arrow buttons to go back.