Listening To Memorized Station Presets; Naming Station Presets - Pioneer VSX-AX5Ai-G Operating Instructions Manual

06 Using the tuner

Listening to memorized station presets

You can do this from both the remote control and the
front panel.
1 Press CLASS to select the class in which the
station is stored.
Press repeatedly to cycle through the three memory
classes, A, B and C.
2 Use the STATION +/– buttons to select the station
memory in which the station is stored.
On the front panel, press SELECT first to switch to the
station select mode for STATION (TUNING) +/–.
• You can also use the number buttons or the
(cursor left/right) buttons on the remote control to
recall the station preset.

Naming station presets

You can input a name of up to four characters for each
preset station in the receiver's memory. For example, you
could input Jazz for that station and when you listen to it
the name, rather than the frequency, will appear in the
front panel display.
TUNER EDIT
ENTER
50
En
STATION DTV MENU CLASS
TUNER
1 Press CLASS repeatedly to select the class.
Press repeatedly to cycle through the three memory
classes, A, B and C.
2 Use the STATION +/– buttons to select an FM or
AM preset station.
On the front panel, press SELECT first to switch to the
station select mode for STATION (TUNING) +/–.
3 Press TUNER EDIT to select the station name
mode.
4 Edit the name as necessary and press ENTER.
Use the
MULTI JOG dial to change the character and ENTER to
confirm (or to add a space if no character is input). The
name can be up to four characters (the possible
characters are listed below).
ABCDEFGHIJKLMNOPQRSTUVWXYZ
+
STATION
abcdefghijklmnopqrstuvwxyz
0123456789
!"#$%&'()*+,–./:;<=>?@[ \ ]^_{|} (space)
To exit the process at any time, press TUNER EDIT.
5 Repeat steps 2 – 4 to memorize up to 30 preset
broadcast station names.
Tip
• To change a station name, just enter the new name
over the top of the old one. To erase a station name,
enter a new name of four spaces.
• You can switch between the frequency display and
the station name display using the remote control
DISP MODE button.
(cursor left/right) buttons or the front panel