Video; Settings - Pioneer VSX-AX10Ai-G Operating Instructions Manual

Additional information

Video

Symptom
No image is output when an
input is selected.
The System Setup screen
doesn't appear.
Color noise appears on the
System Setup screen.
Overlay information doesn't
appear on your TV or monitor.
Can't see or hear television
programs.
There is residual screen noise
after an overlay message
disappears.
Can't record video.

Settings

Symptom
The Auto Surround Setup
continually shows an error.
After using the Auto Surround
Setup, the subwoofer distance
setting is set further than the
actual measured distance.
After using the Auto Surround
Setup, the speaker size setting
(LARGE or SMALL) is incorrect.
Cause
• The video connections are incorrect.
• You are using component video
connections for your source, but not for your
TV.
• You are using component video
connections and the component video inputs
are assigned incorrectly.
• The DVD/video player settings are incorrect. • Set correctly. Refer to the instruction manual supplied
• The video input selected on the TV monitor
is incorrect.
• The MONITOR OUT jack hasn't been
connected.
• Some TVs connected to the receiver with
component video cords do not display the
System Setup screen when the Color Burst
feature is on.
• Some TVs connected to the receiver with
composite video cords display color noise on
the System Setup screen when the Color
Burst feature is off.
• Overlay information doesn't appear when
you are using different types of video cords for
source and TV connections, or when using
component video connections.
• The video input selected on the TV monitor
is incorrect.
• Some TVs exhibit this display problem.
• You are trying to record a source connected
to the component video jacks.
• The source is copy protected.
Cause
• The ambient noise level in the room is too
high.
• The low-pass filter found in subwoofers can
introduce a delay in the playback sound.
• There was some inaudible low-frequency
noise in the room.
Remedy
• Make sure the video component is connected correctly
(see pages 15–19).
• Using the video converter, video signals can be
converted from a composite or S-video input to a
component video output, but not vice-versa. See About the
video converter on page 20 for more on this.
• Check Assigning the component video inputs on page 89
to make sure you're assigned the correct input.
with the DVD/video player.
• Set correctly. Refer to the instruction manual supplied
with the TV.
• Connect the MONITOR OUT jack to the TV monitor (see
Connecting your TV on page 14).
• NTSC model only – When the receiver is in standby,
switch to COLOR BURST OFF by holding down the VIDEO
SELECT button and pressing STANDBY/ON. (the
current setting appears in the display).
• NTSC model only – When the receiver is in standby,
switch to COLOR BURST ON by holding down the VIDEO
SELECT button and pressing STANDBY/ON (the
current setting appears in the display).
• Do not use component video cables if you would like to
see overlay information and use the same type of video
cable (for example, only composite, or only S-video) for
both source and TV connections.
• Set the TV input to the channel you want to watch,
instead of the receiver input.
• This is not a malfunction with this receiver.
• Connect the source component to either the composite
video or the S video jacks (see Connecting your equipment
on page 12).
• You can't record sources that have been copy protected.
Remedy
• Keep the noise level in the room as low as possible
when using the Auto Surround Setup. If the noise cannot
be kept low enough, you will have to set up the surround
sound manually (page 56).
• This is not a malfunction. The Auto Surround Setup has
compensated for the delay caused by the filter.
• The low-frequency noise could have been caused by an
air conditioner or motor. Switch off all appliances in the
room and rerun the Auto Surround Setup.
12
101
En