Programming; Set Time; Set Program Schedule; Factory Default Program - Pro1 Technologies T705 Installation Manual

Tech Settings & Programming
Tech Settings
Select GAS for systems that control
the fan during a call for heat. Select
Fan
ELEC to have the thermostat control
Operation the fan during a call for heat.
This feature will start heating or
cooling early to bring the building
Morning
temperature to its programmed
Recovery
setpoint by the begining of the
WAKE time period.
You can configure this thermostat
to have 5+1+1 programming or
Program
non programmable.
Options

Set Time

(If using programming)
1.
With system switch set to OFF, press the MENU button
2. SET TIME
Press
3.
Day of the week will be flashing. Use the
to select the current day of the week.
4. NEXT STEP
Press
5. The current hour is flashing. Use the
select the current hour. When using 12-hour time, make sure
the correct a.m. or p.m. choice is selected.
6. NEXT STEP
Press
7. Minutes are now flashing. Use the
select current minutes.
8. Press DONE when completed.

Programming

You can use the table below to plan your customized program schedule.
LCD Will Show Adjustment Options
GAS - GS
or
Next Step
ELEC - EL
Prev Step
Use the and key to turn
ON or OFF.
Next Step
Prev Step
Use the and key to
select 5d for 5+1+1, or
Next Step
0d for non programmable.
Prev Step
or
or
or key to
Programming
Programming
Default
All of our programmable thermostats are shipped with an
energy saving pre-program. You can customize this default
GAS
program by following the steps on page 14.
Your thermostat can be programmed to have all the weekdays
the same, a seperate program for Saturday, and a seperate
program for Sunday. There are four time periods for each
ON
(WAKE, LEAVE, RETURN, SLEEP).
program
5d
key
key to
Programming

Set Program Schedule

To customize your program schedule, follow these steps
Weekday:
1. Select HEAT or COOL with the system switch. Note: You have
to program heat and cool each seperately.
2. Press the MENU button
3. Press SET SCHED. Note: Monday-Friday is displayed and the
WAKE icon is shown. You are now programming the wake
time period for the weekday setting.
4. Time is flashing. Use the
selection for the weekday WAKE time period.
5. Press NEXT STEP
6. The setpoint temperature is flashing. Use the
to make your setpoint selection for the weekday wake period.
7. Press NEXT STEP
8. Repeat steps 4 thru 7 for weekday LEAVE time period, for
weekday RETURN time period, and for weekday SLEEP time
period.
Saturday:
Repeat steps 4 thru 7 for the Saturday WAKE time period, for the
Saturday LEAVE time period, for the Saturday RETURN time
period, and for the Saturday SLEEP time period.
Sunday:
Repeat steps 4 thru 7 for the Sunday WAKE time period, for the
Sunday LEAVE time period, for the Sunday RETURN time period,
and for the Sunday SLEEP time period.
(If menu does not appear first press RUN SCHED)
or key to make your time
or key