Engine Oil Top-Up; Warning Light (Insufficient Oil Pressure) (03_03; Engine Oil Change - PIAGGIO BEVERLY Cruiser 250ie Owner's Manual

Hide thumbs Also See for BEVERLY Cruiser 250ie:
Table of Contents

Advertisement

Engine oil top-up

Always check oil level before topping-up and add oil without exceeding the MAX
level. Getting an oil level between the MIN and MAX levels requires ~ 200 cm³ of oil.
Take your vehicle to an Authorised Service Centre to have the engine oil checked
and if necessary, topped-up as indicated in the scheduled maintenance table.

Warning light (insufficient oil pressure) (03_03)

The scooter is equipped with a warning light «H» that lights up when the key is turned
to «ON».
However, this light should switch off once the engine has been started.
If the light comes on during braking, at idling speed or while turning a corner,
it is necessary to check the oil level and top-up if required. If after having topped
up the oil, the warning light still turns on while braking, at idle speed or while
turning a corner, it will be necessary to turn to an Authorised Service Centre.
03_03

Engine oil change (03_04)

The oil and the cartridge filter «C» must be changed as indicated in the scheduled
maintenance table at an Authorised Service Centre. The engine should be emptied
by draining the oil from the drainage plug «B » of the gauze filter on the flywheel side.
In order to facilitate the oil drainage, loosen the cap/dipstick. Since a certain quantity
of oil still remains in the circuit, filling must be done with approx. 600 ÷ 650 cm³ of oil
through the cap «A». Then start up the scooter, leave it running for a few minutes and
switch it off: after five minutes, check the level and if necessary top-up without ex-
ceeding the MAX. level. The cartridge filter must be replaced at every oil change.
For top-ups and changes, use new oil of the recommended type.
03_04
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents