JVC TH-M606 Service Manual page 28

3.4.6 Removing the power board
(See Figs.7 to 9)
• Prior to performing the following procedures, remove the am-
plifier assembly, rear panel, heat sink bracket and amplifier
board.
(1) From the right side of the amplifier assembly, remove the
five screws J attaching the power board. (See Fig.7)
(2) From the top side of the amplifier assembly, disconnect the
wires from the connectors
board. (See Fig.8)
(3) Disconnect the power cord from the connector
the power board, and take out the power cord. (See Fig.8)
(4) Disconnect the wire from the connector
board. (See Fig.9)
(5) Disconnect the power board from the connectors CN301,
CN302 and CN303 on the ma in board, and take out the
power board assembly from the amplifier assembly. (See
Fig.8)
Reference:
Remove the screw K attach the barrier as required. (See Fig.7)
1-28 (No.MB198)
CN312 and CN321 on the power
CN311
CN501 on the LED
J
on
Power board
Main board
CN311 CN312 CN303 CN302 CN301 CN321
Power cord
Power board
Barrier
J
K
Fig.7
Wire clamps
Power board
Fig.8
LED board CN501
Fig.9