Download Print this page

SWS SeceuroGlide Manual Installation Instructions Manual

Roller garage door
Hide thumbs Also See for SeceuroGlide Manual:

Advertisement

www.samsondoors.co.uk
SeceuroGlide Manual
Installation Instructions
Always check on delivery that the order details are correct and the
door is undamaged and especially before removing any existing doors.
Sequence of Installation & Contents
01. Pre-Installation and Component Check
02. Prepare the Opening
03. Installation Options
04. Prepare the Guide Rails
05. Fit End Plates and Guides
06. Install Axle Assembly
07. Install the Curtain in the Guides, Tension the Spring & Attach Curtain to Axle,
Preparing the Guide Rails for the Lock Bar
08. Curtain Adjustment (reducing height / making repairs)
09. Commissioning
10. Technical Assistance
11. Notes
01. PRE-INSTALLATION AND COMPONENT CHECK
Check:
i.
Delivery note
ii. Order sheet
iii. Door dimensions / colour
iv. Opening dimensions / clearances
v.
Components
vi. Check for any damage to the guide rails
or the outside roll of the curtain
Do not proceed further with the
installation unless you are sure that
the door is the correct size, and all
components are present.
August 2016
Issue 1
SGM16
0800 328 6250
Drive Through Height
Drive Through Width
Over Guide Width
www.samsondoors.co.uk
PLEASE NOTE
These instructions have been produced
assuming that this door will be installed
by two engineers to assist with the
tensioning of the spring.
WIDTHS
Order Width = Over Guide Width
Drive Through Width = Over Guide Width less
150mm for 75mm guides
HEIGHTS
Order Height = Guide Height
Total Height = Guide Height + End Plate
Headroom/End Plate
up to 2.3m Guide Height = 300mm
Drive Through Height = Guide Height less
105mm
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the SeceuroGlide Manual and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SWS SeceuroGlide Manual

  • Page 1 0800 328 6250 www.samsondoors.co.uk SeceuroGlide Manual Installation Instructions Always check on delivery that the order details are correct and the door is undamaged and especially before removing any existing doors. Sequence of Installation & Contents 01. Pre-Installation and Component Check 02.
  • Page 2 www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk MANUAL ROLLER GARAGE DOOR COMPONENTS 01. Pull Down Cord * 02. Spring (fitted into axle) 03. 102mm Round Axle 04. Locking Collars (fitted to axle 6 No. up to 2.5m, 8 No. up to 3m) 05.
  • Page 3 www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk 03. INSTALLATION OPTIONS Internal installation only Minimum number of fixings per guide rail The garage door must be Due to the additional forces that a manually operated door is installed internally subjected to we recommend that you use the minimum number of fixings stated above.
  • Page 4 www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk 05. FIT END PLATES AND GUIDES N.B. When fitting doors it is important that you check that the Before proceeding any further check: lintel does not bow inwards or have any projections that may a) Back faces of guides and end plates are flush and catch on the curtain.
  • Page 5 www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk 07. INSTALL THE CURTAIN IN THE GUIDES Check that there are at least 3 pairs of collars on the axle and N.B. Do not allow the curtain to free fall over the axle as this that they are facing the correct direction –...
  • Page 6 www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk PREPARING THE GUIDE RAILS FOR THE LOCK BAR ix. Lower the door to the fully closed position. Using a pencil During normal operation the door will be unlocked from the mark on the guide rails the height where the lock bar enters outside and the user will push the curtain towards the inside.
  • Page 7: Final Checks

    www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk 09. COMMISSIONING Final Checks N.B. Check the front of the curtain to make sure that it is not Remove any protective plastic coverings rubbing on the fascia etc. ii. Wipe curtain & guides with damp cloth Upon completion it is your responsibility to train the customer iii.