Installation - Sanyo EM-P842T Instruction Manual And Cooking Manual

p410sfc-assembly.fm Page 9 Tuesday, February 16, 1999 2:00 PM

INSTALLATION

Remove all packing material and accessories. Examine the oven for any
damage such as dents or broken door. Do not install if oven is damaged.
NOTE: This unit is not designed for 50 Hz or any circuit other than a 120-volt/
60-Hz AC circuit. This oven is designed for countertop installation.
Countertop Installation
1. Select a level surface that
provides enough open space for
the intake and/or outlet vents.
3"
A minimum clearance of 3 inches is
required between the oven and any
adjacent wall. One side must be open.
• Leave a minimum clearance of
3 inches above the oven.
• Do not remove the legs from the
bottom of the oven.
• Blocking the intake and/or outlet
openings can damage the oven.
3"
• Place the oven as far away from
radios and T.V.'s as possible.
Operation of microwave oven may
3"
cause interference to your radio or
OPEN
TV.
• If the cabinet is covered with a
protective film, remove the film.
2. Plug your oven into a standard
120-volt / 60-Hz household outlet.
Be sure the electrical circuit is at
least 15 amperes and that your
microwave oven is the only
appliance on the circuit.
WARNING: Do not install oven over a
range cooktop or other heat-
producing appliance. If installed near
or over a heat source, the oven could
be damaged and the warranty would
be void.
9