Advertisement
2) Using the PCB parts diagrams in Drawing 1,2, and 3, place all of the slid-
er assemblies into the PCB as shown in figure 1. DO NOT SOLDER YET. This
allows for the chance to test fit the assemblies, and also makes it easier to
wire the sliders together. Be sure to use the slider adapter with the transis-
tor driver for the LFO RATE slider. This slider adapter allows the LFO to mod-
ulate the brightness of that slider's LED.
3) Double check the slider values and tapers. Using the jumper cables in-
cluded with the sliders, begin wiring the slider assemblies as shown in fig-
ures XX-XX. Be sure to wire all V+ pins together, and all GND pins together. It
is easy to make a mistake and reverse the polarities when using the longer
cables. Be sure to double check your work before you solder.
Figure 2 - Slider Wiring Assembly Completed. (Sliders still just loosely placed into PCB. ARP Omni 2 shown)
Build wire assemblies. When completed, the assemblies should still be
placed loosely into the PCB, as shown in Figure 2.
4) Using elastic bands, clips or other means, hold the sliders into place so
the PCB can be flipped over for soldering. Don't worry if the sliders are
straight. They will all be aligned and straightened when the assembly is tack
soldered into place. THE SLIDERS MUST BE TACK SOLDERED INTO PLACE BY
ONLY ONE PIN. This will allow the slider assemblies to be held in place on
each PCB while each slider is leveled and aligned.
Advertisement
