Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Hisense X08060026B
Summary of Contents for Hisense X08060026B
- Page 1 X08060026B...
- Page 3 IFU. ensure Thank you for choosing a Hisense washing machine. Before operating your new washing machine, please read this instruction carefully, and keep it for future reference. If you have lost it accidentally, ask customer service for e-copy or hard copy.
- Page 4 that that The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for there cyclingof electrical and electronic equipment.
-
Page 5: Description Of The Washing Machine
BEFORE THE FIRST WASH CYCLE Clean the outside of the washing machine with a damp cloth. Do not use abrasive detergents. To remove any residual water used during testing by the manufacture r, we Never open the door forcibly or use it as a step. recommend that you carry out a short wash cycle without laundry. - Page 6 Open the door. / soak...
-
Page 7: Draining Residual Water
unds Press the release lever in the main wash compartment downward and remove the drawer(fig.“B”). Select the “Rinse+Spin” programme,reduce the speed to 1000rpm and strat Remove siphon in softener slot. (fig.“C”). Refit the siphon in the detergent drawer and fit the drawer back inside its housing. DRAINING RESIDUAL WATER (depends on model) Before emptying the residual water, switch the appliance off and unplug it... - Page 8 Put a flat container under filter door and then drain with emergency drain pipe (see [draining residual water] for specific operation methods). Then, loosen filter anticlockwise and completely unscrew and remove the filter. Check the supply hose regularly for brittleness and cracks and replace it if necessary using a new hose of the same type(available from After-Sales Service or specialist dealer).
- Page 9 solv and the power switched remove some...
-
Page 10: Hot/Cold Fill Fault
Hot / Cold fill fault - For Models with Dual Inlets Fault Code List If you wish to connect hot and cold water supply (Fig.1): 1 Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red Displayed on Display Window Fault Description filter on the rear side of machine. -
Page 11: Electrical Connection
C. Fault code TRANSPORT/HANDING The washer stops when the program is running. The display window shows fault code “F24”, fault codes from “F04 ’ to “F07”, “F13”, “F23” or “UNB”. If fault code “F24” is shown Water level reaches overflow level. Remove it by pressing “Start/Pause”...
Need help?
Do you have a question about the X08060026B and is the answer not in the manual?
Questions and answers