Pioneer YPM-MG2196ZF Service Manual page 44

YPM-MG2196ZF
10. Remove the screw, pressure spring and collar. Lift
up the Carriage mech assy to remove it.
* Screw tightening torque: 2.6kgfcm
- How to remove the Pickup unit
1. Remove the pulling spring, torsion spring and E type
washer. Then remove the Clamper arm.
* The spring (A) will be removed with the Clamper
arm.
2. Slide the Clamp UP lever (B) to remove it.
3. Loosen the 2 screws. Remove the feed-screw cover
by sliding it.
4. Remove the feed-screw pressure spring (D).
5. Loosen the 2 screws. Remove the feed-screw holder
(E).
6. Remove the belt.
44
Carriage
motor
Pickup
unit
Belt
Feed screw
Pressure spring
Pulling spring
Torsion spring
7. Remove the Pickup unit together with the feed screw.
* Be careful not to lose the shaft holders at the both
ends of the feed screw.
* Be careful not to damage the 2 flexible PCBs(for the
Pickup and motor) when separating them. The flexi-
ble PCBs have been stuck each other with double-
sided adhesive tape.
White
Black
Fig. 6
Screw
Collar
Carriage mech
Assy
Fig. 4
E type washer
Clamper arm
Fig. 5