Fitted units
•
This appliance is only intended to be fully fitted in a kitchen.
This appliance is not
•
The fitted cabinet must not have a back wall behind the appliance.
•
A gap of at least 45
•
panel of the unit above.
The fitted cabinet must have a ventilation opening of 50
•
achieve this, cut back the base panel or fit a ventilation grille.
Ventilation slots and intakes must not be covered.
•
The safe operation of this appliance can only be guaranteed if it has been installed in
•
accordance with these installation instructions.
The fitter is liable for any damage resulting from incorrect installation.
•
The units into which the appliance is fitted must be heat resistant
•
up to 90 ºC .
Installation dimensions
Note: There should be gap above the oven.
Building in
•
Do not hold or carry the appliance by the door handle. The door handle cannot hold
the weight of the appliance and may break off.
1. Carefully push the
2. Open the door and fasten the
designed to be used as a tabletop appliance or inside a cupboard.
100 mm must be maintained
min 100
Ventilation grid
oven
into the box, making sure that it is in the centre.
oven
with the screws that were supplied.
between the wall and the base or back
cm
250
min 100
460
Cupboard feet
9
2
on the front. To
50
250