Maintenance & Technical Support - MAKERGEAR M2 User Manual

Maintenance & Support
Ensure that your bed is at the correct hight and properly
leveled. To do so, open the MakerGear Quick Start application
and follow the commands within the Set Up process in order to
complete the following steps:
1) Check Starting Height
Ensure that the print surface is free of defects (torn or bubbled
tape) and dust/dirt/grease, and replace tape or clean surface
with appropriate cleaner (alcohol/water at
50%/50%recommended).
Monthly (every 200-250 hours)
Ensure the machine is free of dust and filament debris, and clean
if necessary. Focus areas include fans and fan guards, filament
surface and filament drive, and the entire frame. Clean oil from
the X and Y linear rails and apply a fresh coat to each. A dot of
oil in each of the long grooves on the X and Y rails is sufficient.
Once applied, move that axis through its full travel multiple
times to spread the oil.
For more maintenance tips
visit MakerGear.wikidot.com
Technical Support
at www.makergear.com/pages/support
Weekly (every 50 hours)
lives on our website
2) Check Bed Level
16