Makita 4101RH Instruction Manual page 9

1
1. Cover (B)
2. Screw
1. Limit mark
1 2 2
1. Brush holder cap
2. Screwdriver
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Diamond wheels
• Hex wrench 5
When changing the wheel, clean the cover (B) at the same time. Loosen the
003549
screw securing the cover (B) and remove the cover (B). Wash off accumula-
tion of dust inside the cover (B) and wipe it. Then attach the cover (B) to the
tool by tightening the screw. Accumulation of dust inside the covers may
2
cause a malfunction of the tool.
CAUTION:
• When using the tool, be sure to attach the covers (A) and (B).
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
First, remove the cover (A).
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
003550
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
• Wrench 22
• Rip fence (Guide rule)
9