Table of Contents
Advertisement
SINELINK24G
2-5 Connect to LAN equipments
This product complies with IEEE802.3af. It can be connected with LAN equipments,
such as Switching HUB, through PoE supply apparatus. (Follow the instruction below)
LAN cable
=Distance to Switching HUB should be less than 100m.
=LAN cable should be straight cable.
(In case Switching HUB is "Auto MDI/MDI-X" applied, it can be connected with
cross cable)
Switching HUB
=100BASE-TX(100Mbps, Full duplex)
NOTE: This product does not support 10Mbps or Semi duplex communication.
=Connection port setting should be "Auto Negotiation" or 100Mbps Fixed Full
duplex.
*NOTE: This product does not have filtering function by MAC address, etc.
In case necessary, Filtering must be done at LAN equipments of Switching HUB side.
2-6 Confirm the RF status
RF status can be confirmed through WWW browser of the connected tool (PC)
Please refer to item 3-3(3) below.
If the "Distance" or "Rx level" does not show proper level, it might be possible that
the Antenna direction is not settled properly, or any obstructs is blocking.
20
Advertisement
Table of Contents
