Hitachi SINELINK 24G User Manual page 22

SINELINK24G
9 Connect the LAN cable
(with water protection
cap/ refer to 2-3)
13 Check the LAN cable
quality using
tester.
14 Screw in the
protection cap
connecting RJ45
connector to the
product. Tight certainly
the connector by hand.
Fixing Torque should be
2.26[N/m](23 [kgf/cm])
(To the extent that O
ring would
compressed)
Roll self-melting tape
and vinyl tape on the
water protection cap.
Wire the LAN cable to
the extent that no stress
would be add to
connector portion.
15 Connect RJ45
connector to PoE
apparatus.
Wire the LAN cable to
the extent that no stress
would be add to
connector portion.
Shielded RJ45 connector
(Check points)
Cable = All 8 cable cores are connected straightly.
= No communication problem at 100BASE-TX
= Cable length should be less than 100m
= Communication quality would not be changed in
case RJ45 connector portion is touched slightly.
water
after
be
19
Water protection cap
Screw in, to the extent that O ring would
be compressed
Fix the water
protection cap
and roll
self-melting tape
and vinyl tape on it.