Table of Contents
Advertisement
02
Connecting up
Chapter 2
Connecting up
Important
• Before making or changing any
connections, switch off the power and
unplug the power cord from the AC outlet.
• When making cable connections, make
sure not to bend the cables over the top of
this unit. This may cause a humming noise
from the speakers.
Connecting the speaker
terminals
Place the front left and right speakers at equal
distances from the TV
from the speakers to the terminals on the main
unit rear panel as shown below. See Optional
surround speaker connections on page 6 to
connect surround speakers.
Caution
• Do not connect this speaker to any amplifier
other than the one supplied with this
system. Connection to any other amplifier
may result in a malfunction or fire.
• Make sure that the bare speaker wires
cannot touch each other, or come into
contact with other metal parts once the
unit is switched on.
• Do not attach these speakers to the wall or
ceiling. They may fall off and cause injury.
Note
1 The speakers supplied with this system are magnetically shielded. However, placing them extremely close to a television may
result in color distortion on the screen. If this happens, move the speakers a little further away and switch off the television for
15–30 minutes.
6
En
1
, then connect the wires
1
Twist and pull off the protective shields
on each wire.
2
Connect to the FRONT speaker terminals
on the rear of the unit.
Make sure to insert the red wire into the red (+)
tab and the black wire into the black (–) tab.
Optional surround speaker
connections
Using RCA speaker cables, you can connect
surround speakers to the left and right
SURROUND speaker jacks on the rear panel
for multichannel sound from this system.
For the best surround effect, place the
surround speakers slightly above ear level and
at the same distance from the listening
position as the front speakers.
Important
• Use speakers with a nominal impedance of
at least 16Ω.
ª
·
Hide quick links:
Advertisement
Table of Contents
