Table of Contents
Advertisement
sponge or cloth and rinse the seat covers with clean water to remove
all trace of soap or detergent. Rub briskly with a bath towel and allow
the covers to dry. Should you desire to remove the seat covers to wash
them, slip the covers off, place them in a washing machine.or laundry
tub and wash them. Rinse the covers thoroughly with clear water,
wring out and replace them on the cushions wet. (Wet covers will
not harm the upholstery.)
In a short time (usually less than an hour) the covers will dry to a
tight glove fit ready for use.
WINDSHIELD WASHER ALL-SEASON SOLVENT -GM Wind-
shield Washer All-Season Solvent, for year around use in GM wind-
shield washers, is available. This solvent, when mixed with water,
acts as a wetting agent, decreasing the surface tension of the water
on the outside of the glass. The wetting action enables the solution to
remove road splash, oil, grime, insects and dust that have accumu-
lated on the windshield thereby improving vision and eliminating
eyestrain.
For spring, summer and early fall use, pour 1 oz. of solvent into the
windshield wash jar and fill jar with water.
During late fall and winter months to prevent jar breakage due to
freezing, pour 2 ozs. of solvent into jar and fill with water to
%:
level
as indicated on bracket label. The windshield washer should not be
used during sub-freezing weather as the solution will freeze on
windshield.
GM Windshield Washer All-Season Solvent is not injurious to car
finish, metal or rubber parts when used as directed.
PONTIAC ELECTRIC CLOCK
Regulating the Clock-The regulator screw is located at the top of
the bezel. If the clock is running consistently slow set the regulator
by inserting a small screw driver in the slot and turn towards "F"
or to the
right.
If running fast turn regulator towards
"s"
or to the
left. Approximately a quarter turn of the regulator adjusting screw
is equivalent to about five minutes, gain or loss, per day.
It is suggested that after making an adjustment the clock be allowed
to run for approximately one week at which time it should be checked
and readjusted if necessary.
Setting the Clock-Pull out on reset stem to engaged position, .
turn hands to correct time and release stem. It is well to push in on
stem at time it is released to make certain that it fully
disengages.
[ 45)
Advertisement
Table of Contents
