Calibration - Raymarine Race Master User Manual

6

Calibration

Once the Race Master has been installed on the vessel and Auto
Networking has been completed it is necessary to calibrate the
compass. It is not safe to use the Race Master for navigational purposes
until calibration has been carried out correctly.
To compensate for deviation caused by magnetic objects on the boat, it
is necessary to carry out a deviation correction turn.
The compass reading may be set to the correct heading.
To begin the calibration process
From the Line Bias (LiNE) page, press and hold
enter Setup.
Press
To complete a deviation correction turn
Press
Note: If the rate of turn of the vessel is too fast the display will show
"FAST TRN". It is not necessary to abandon the turn at this stage but do
lessen the rate of turn by reducing speed or widening the turning circle.
Press
Then, to align the heading
Using a hand bearing compass or an external fixed compass, steer the
vessel on a known heading.
Warning: Only use an external fixed compass as a known heading if you
are certain it has been checked and compensated.
Press
repeatedly to scroll to the Heading chapter.
to scroll to the DEV parameter.
Press to enter Compass Calibration Mode.
Turn the vessel slowly keeping the speed below 4 knots and
taking approximately 2 minutes to complete 360 degrees. Keep
turning the vessel until the display changes to show a value
(usually about 1.25 turns).
to exit Compass Calibration Mode.
repeatedly to scroll to the Compass Offset page.
Press to enter Edit Mode.
Press or
to the known correct value.
The display shows the offset entered.
Press to exit Edit Mode.
Press and hold
to change the displayed heading (in small text)
to exit Setup and return to normal operation.
Calibration
for 2 seconds to
17