Table of Contents
Advertisement
4
Advanced Operation
To set the Mean Wind Direction (MWD) and Tack Angle (TAK) by
sailing closehauled
1 Go to the Wind Shift (WND) page.
2. Sail upwind for several minutes to determine your average close
hauled heading on each tack.
3. Steer your average close hauled heading on either tack.
4 Press
two seconds.
5 Tack and sail your average close hauled heading on the new tack.
6 Press
(TAK) pop-up will be displayed.
The Tack Angle (TAK) can be adjusted using
To set the Mean Wind Direction (MWD) to a known value
If you know the required Mean Wind Direction (MWD), you can set it at
any time as follows (you do not need to be sailing):
1 Go to the Wind Shift (WND) page.
2 Press and hold
3 Press
4 Set the desired heading using
To set the Tack Angle (TAK) to a known value
If you know the required Tack Angle (TAK), you can set it at any time as
follows (you do not need to be sailing):
1 Follow the procedure above to display the Mean Wind Direction
(MWD) pop-up.
2 Press
3 Set the required value using
, the display will beep twice and "TAC NOW" will show for
again, the display will beep three times and the Tack Angle
for 2 seconds, rotating lines are shown.
, the Mean Wind Direction (MWD) pop-up is displayed.
, the Tack Angle (TAK) pop-up is displayed.
Advanced Operation
and
and
.
and
.
.
11
Hide quick links:
Advertisement
Table of Contents
