Advertisement
These Operator Instructions must be kept in good preservation conditions, in a place easily
accessible to the appointed personnel. These Operator Instructions are not exempt from
compliance with the laws in force regarding safety and on-the-job injury protection regulations.
ONDA S.p.A. SHALL NOT BE LIABLE in the case of:
improper use of equipment under pressure;
alterations of the equipment under pressure;
non-compliance with safety regulations in force;
non-compliance with the content of these Operator Instructions.
The plate exchangers are composed of a pile of corrugated plates, stacked onto each other
between two closure plates. The pile of plates is subjected to a process of brazing with the
forming of two separate circuits.
Before carrying out any operation on the exchanger, check the correspondence between the
ordered machine and the received one. Please also verify that the model of the exchanger has
been adequately sized with the ONDA selection programme for the type of application.
3.1 Enclosed documents
These Operator Instructions are always enclosed with the exchanger.
LIFTING
AND
PERFORMED BY QUALIFIED PERSONNEL
The plate exchanger includes attachments that protrude from the space occupied by the
equipment under pressure. It is therefore recommended to handle with maximum care to prevent
any impact or damage to the protruding parts.
Before handling the exchanger, it is necessary to verify the size and weight of the exchanger,
written to allow the choice of an adequate lifting system.
A steel or synthetic fibre lashing must be used, with payload exceeding the weight of the load to
be handled.
For exchangers of particular dimensions, please use the eyebolts specifically required for the
exchanger:
1. PRELIMNARY CAUTIONS
2. INTRODUCTION
3. MATERIAL DELIVERY
4. HANDLING AND TRANSPORTATION
TRANSPORTATION
MANEUVRES
5
MUST
BE
Advertisement
