Related Manuals for Bürkert 0400
Summary of Contents for Bürkert 0400
- Page 1 Type 0400 2/2-way solenoid valve 2/2-Wege-Magnetventil Électrovanne 2/2 voies Operating Instructions Bedienungsanleitung Manuel d‘utilisation...
-
Page 2: Table Of Contents
OperaTing insTrucTiOns Contents The operating instructions contain important information. 1 Operating instructions ......................2 ▶ Read the operating instructions carefully and follow the safety instruc- 2 Intended use ...........................3 tions in particular, and also observe the operating conditions. ▶ Operating instructions must be available to each user. 3 Basic safety instructions.......................3 ▶... -
Page 3: Intended Use
Basic safeTy insTrucTiOns These safety instructions do not make allowance for any contingencies Incorrect use of the solenoid valve Type 0400 can be dangerous and events which may arise during installation, operation and maintenance. to people, nearby equipment and the environment. - Page 4 ▶ Ensure seals are seated correctly. ▶ Carefully screw valve and connection lines together. 3.2 information on the internet The operating instructions for type 0400 can be found on the internet at: www.burkert.com Type 0400 General hazardous situations.
-
Page 5: Technical Data
Technical daTa Special instructions for valves circuit function B (NO) with deaeration connection G1/8 on the coil: 4.1 Operating conditions The deenergized valve is open. The The following values are indicated on the type label: medium also flows off via the deaeration •... - Page 6 Voltage, Frequency, Power 00041404 W12MN consumption solutions EC mark (if applicable) Identity number 4.3 conformity Date of manufacture In accordance with the EC Declaration of conformity, the solenoid valve Type 0400 is compliant with the EC Directives (if applicable). english...
-
Page 7: Installation
insTallaTiOn 5.2 Before installation Installation position: any, coil preferably upwards. 5.1 safety instructions → Check pipelines for dirt and clean. Danger! → Install a dirt filter before the valve inlet (≤ 500 µm). Risk of injury from high pressure in the equipment. note! ▶... - Page 8 5.3 electrical connection of the cable plug Seal Warning! max. 1 Nm Authorized cable plug Risk of injury due to electrical shock. e.g. Type 2508 or other suitable ▶ Before reaching into the system, switch off the power supply and cable plug in accordance with secure to prevent reactivation.
-
Page 9: Maintenance, Troubleshooting
MainTenance, TrOuBleshOOTing Possible cause if the valve does not switch: • Short circuit or coil interrupted. Warning! • Inadequate power supply. Risk of injury from improper maintenance. • Core or core area dirty. ▶ Maintenance may be carried out by authorized technicians only and •... -
Page 10: Spare Parts
spare parTs 7.2 Overview of spare parts Caution! Spare parts set for Spare parts set for circuit function A circuit function B Risk of injury and/or damage by the use of incorrect parts. Incorrect accessories and unsuitable spare parts may cause injuries and damage the device and the surrounding area. -
Page 11: Transport, Storage, Disposal
TranspOrT, sTOrage, dispOsal note! Transport damages. Inadequately protected equipment may be damaged during transport. • During transportation protect the device against wet and dirt in shock-resistant packaging. • Avoid exceeding or dropping below the allowable storage temperature. Incorrect storage may damage the device. •... - Page 12 Bürkert Fluid Control Systems Sales Center Christian-Bürkert-Str. 13-17 D-74653 Ingelfingen Tel. + 49 (0) 7940 - 10 91 111 Fax + 49 (0) 7940 - 10 91 448 E-mail: info@de.buerkert.com international address www.burkert.com Manuals and data sheets on the Internet: www.burkert.com Bedienungsanleitungen und Datenblätter im Internet: www.buerkert.de Manuel d'utilisation et fiches techniques sur Internet : www.buerkert.fr ©...