Preparation
Connecting the power cord
Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
Media Receiver (rear view)
DIGITAL OUT
(TS)
DTV-ANTENNA
OPTICAL
I N
OUT
S400
SERVICE ONLY
CONTROL
VCR
CONTROL
INPUT 2
INPUT 1
I N
I N
S-VIDEO
COMPONENT VIDEO
VIDEO
R-AUDIO-L
VIDEO
R-AUDIO-L
Y
OUT
OUT
A ANTENNA/CABLE B
VIDEO
R-AUDIO-L
R-AUDIO-L
INPUT 3
Y
MONITOR OUT
S-VIDEO
S-VIDEO
• Use only the power cord provided.
• Do not use a power supply voltage other than
that indicated as this may cause fire or electric
shock.
• For the Plasma Display System, a three-core
power cord with a ground terminal is used for
efficiency protection. Always connect the power
cord to a three-pronged outlet and make sure
that the cord is properly grounded. If you use a
power source converter plug, use an outlet with
a ground terminal and screw down the ground
line.
PDP-ELITE-Eng (17-27)
IN
AC INLET
C
/P
C
/P
B
B
R
R
BLACK
WHITE
C
/P
C
/P
SYSTEM CABLE
B
B
R
R
27
Power cord
Noise filter
Partially eliminates noise
caused by the power source.
AC INLET
Power cord
Noise filter
Partially eliminates noise
caused by the power source.
• Always turn off the power of the Plasma Display and
Media Receiver when connecting the power cords.
• Disconnect the power cord from the power outlet
when the Plasma Display System is not going to be
used for a long period of time.
9/9/03, 11:44
07
27
En