Maintenance - ProMariner ProNautic1210P Instruction Manual

21

Maintenance

This unit is solid state and requires no constant adjustment or constant attention; however,
the following items should be checked:
Maintenance Item
Verify LED status panel shows no fault condition and indicates
normal operation.
Condition of fuses/breakers check for as-new condition on fuses
(e.g. no discoloration or corrosion) and that a breaker will manually
trip and reset.
Check for proper ventilation and that no debris has collected on
the fan shroud or items have been improperly stored around the
ProNauticP
Check battery terminal connections (both at battery and
the ProNauticP Charger) for corrosion, clean and reconnect
immediately upon signs of corrosion.
Per manufacturer's instructions, check and top off batteries with
distilled water. Use of tap or bottled drinking water will damage
battery plates due to mineral content.
Check wire condition, overheating due to excessively long
or too small conductors will result in hardening of the insulation
or even burn marks at connections; If any of these signs exist,
immediately remedy the situation by installing the
proper conductors.
Start Up Monthly