Quick-Start; Figure - Pyle PHMD2 Instruction Manual

 Volume: Is used to adjust the loudness of the speaker.
 Low Batter: When the red LED lights, indicates the user should replace the
batteries.
 Target Button: Press and hold the red Target Button, the detector mode will
convert from motion mode to no-motion mode and the detector won't
discriminate objects anymore. At this time as long as the search coil approaches
the metals slowly the detector will respond. The closer the distance is, the louder
the sound will be. It may help to pinpoint the target position.
 Earphone Jack: This is located on the back of the control housing. When the
earphone is plugged in, the speaker will no longer sound.
Quick Start:
To master how to operate the metal detector quickly we suggest that you should
read the quick start carefully and practice indoor. When you are familiar with the
detector, you can hunt for the treasures.
1. Prepare with a sort of metal samples
 an iron nail
 a pull-tab and a five cents nickel coin
 a 25 cent silver coin
2. Lay the metal detector properly
In order to avoid the metals influence the detector, be sure to lay the metal
detector properly.
 Place the detector on a wooden or plastic table. Let the search coil exceeds the
table edge about more than 6 inches(15cm),keep the flat part points
outwards(Fig.8).Please note the locations of the search coil and aluminium tube,
don't mistake them(Fig.9).

Figure.8