Trouble Shooting Guide - Pyle PHMD2 Instruction Manual

TROUBLE SHOOTING GUIDE

SYMPTOM
No power, no start up sound.
Sound a successive "DI" "DI" tone
Sound an irregular tone.
Press TARGET button, when the search
coil approaching the ground without any
metals, the unit still sounds a tone.
PARTS LIST
SOLUTION
1. Be sure that the polarity of batteries are
installed correctly.
2. Be sure that the up-side of the battery
cover is up.
3. Replace the batteries.
1. Make sure that there is no other metal
detector operating around.
2. The position of the search coil is lay
correctly(Fig.9).
1. Don't use it indoors, because there is
many metals there.
2. Make sure
electromagnetic interference
such as power lines, cables, electronic
fences and so on. Keep away from these
areas that there are interference existed,or
try reducing the sensitivity.
3. Change the detection place, in order to
distinguish whether it can get more stable
signal.
4. If the target is buried deep, you can try
increasing the sensitivity or you should
add the search coil moving speed in order
to get stable signal.
5. It may be several metals buried there.
6. You may find a severe oxidation target
or the surface is severely magnetized.
You could try reducing the sensitivity.
The surface is severe magnetic. Release
and then press the TARGET button again
in order to reduce the sensitivity.
PARTS LIST
whether there is
sources;