Table of Contents
Advertisement
Assembly
Assembly is easy and requires no special tools.
1. Align the plastic trapeziform raised part on the handle, with the trapeziform lower
groove at the control box bottom (Figure.1). push the two parts tightly together.
2. Align the threaded bolts at the handle bottom, with the knobs under the control
box; lock it with the bolts (Figure.2).
3. Turn the stem's lock nut clockwise until it loosens. This will enable lengthening or
shortening of the stem. When you stand upright with the detector in your hand, the
search coil should be about 1/2 inch above the ground with your arm relaxed at
your side.( Figure.3).
Figure.1
Figure.2
Figure.3
Advertisement
Table of Contents
