Drying Hints - Zanussi ZWT 71401 WA User Manual

cellulose structure will already have been dam-
aged and the fabric tends to hole.
Mould stains: treat with bleach, rinse well
(whites and fast coloureds only).
Grass: soap lightly and treat with bleach
(whites and fast coloureds only).
Ball point pen and glue: moisten with ace-
1)
tone , lay the garment on a soft cloth and dab
the stain.
Lipstick: moisten with acetone as above, then
treat stains with methylated spirits. Treat any re-
sidual marks with bleach.
Red wine: soak in water and detergent, rinse
and treat with acetic or citric acid, then rinse.
Treat any residual marks with bleach.
Ink: depending on the type of ink, moisten the
fabric first with acetone
treat any residual marks on white fabrics with
bleach and then rinse thoroughly.
Tar stains: first treat with stain remover, me-
thylated spirits or benzine, then rub with deter-
gent paste.
Detergents and additives
Good washing results also depend on the
choice of detergent and use of the correct
quantities to avoid waste and protect the envi-
ronment.
Although biodegradable, detergents contain
substances which, in large quantities, can up-
set the delicate balance of nature.
The choice of detergent will depend on the
type of fabric (delicates, woollens, cottons,
etc.), the colour, washing temperature and de-
gree of soiling.
All commonly available washing machine deter-
gents may be used in this appliance:
• powder detergents for all types of fabric
• powder detergents for delicate fabrics (60°C
max) and woollens

Drying Hints

Preparing the drying cycle
As a dryer, the appliance works on the conden-
sation principle.
Therefore, the water tap must be open
and the drain hose must drain water into
1) do not use acetone on artificial silk
14
1)
, then with acetic acid;
• liquid detergents, preferably for low tempera-
ture wash programmes (60°C max) for all
types of fabric, or special for woollens only.
The detergent and any additives must be
placed in the appropriate compartments of the
dispenser drawer before starting the wash pro-
gramme.
If using liquid detergents, a programme with-
out prewash must be selected.
Your appliance incorporates a recirculation sys-
tem which allows an optimal use of the concen-
trated detergent.
Follow the product manufacturer's recommen-
dations on quantities to use and do not ex-
ceed the «MAX» mark in the detergent
dispenser drawer.
Degrees of water hardness
Water hardness is classified in so-called "de-
grees" of hardness. Information on hardness of
the water in your area can be obtained from the
relevant water supply company, or from your lo-
cal authority.
A water softener must be added when wa-
ter has a medium-high degree of hardness
(from degree of hardness II). Follow the manu-
facturer's instructions. The quantity of detergent
can then always be adjusted to degree of hard-
ness I (= soft).
Charac-
Level
teristic
1 soft
2 medium
3 hard
4 very hard
a sink or into the drain pipe, even during
the drying cycle.
Attention!
Degrees of water
hardness
German French
°dH °T.H.
0-7 0-15
8-14 16-25
15-21 26-37
> 21 > 37
www.zanussi.com