Zanussi ZWT 71401 WA User Manual page 11

– The programme will start after the selec-
ted delay has expired.
Cancelling the delayed start after having press-
ed button 8:
1. Set the washing machine to PAUSE by
pressing button 8.
2. Press button 10 once until the symbol
is displayed
3. Press button 8 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start can not be selected with
DRAIN programme.
Start the programme by pressing button 8
To start the selected programme, press the
button 8, the green pilot light of the button 8
stops blinking.
To interrupt a programme which is running,
press the button 8: the green pilot light starts
blinking.
To restart the programme from the point at
which it was interrupted, press the button 8
again. If you have chosen a delayed start, the
machine will begin the countdown. If an incor-
rect option is selected, the red pilot light of the
button 8 blinks 3 times and the message Err is
displayed for a few seconds.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must PAUSE
the appliance by pressing the button 8.
Changing a running programme is possible only
by resetting it. Turn the programme selector di-
al to O and then to the new programme posi-
tion. Start the new programme by pressing the
button 8 again. The washing water in the tub
will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
www.zanussi.com
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
'
At the end of the programme
The machine stops automatically. Three blinking
0.00 appear on the display and the pilot light of
button 8 goes off. Some acoustic signals
sound.
If a programme or an option that ends with wa-
ter left in the tub has been selected, the door
remains locked to indicate that the water must
be emptied out before opening the door.
Follow the below instructions to empty out the
water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to O to switch the ma-
chine off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
Stand By: If your laundry is not removed within
10 minutes after the programme is finished, the
back light of the display switches off and the
energy saving system will be enabled. Only the
pilot light of the button 8 is blinking to indicate
that the appliance has to be switched off. By
pressing any button the appliance will come out
from the energy saving status and you can set
another programme or switch the appliance off.
to cancel a pro-
11