Additional Information; Resetting The Recorder; Setting Up The Remote To Control Your Tv - Pioneer DVR-420H Operating Instructions Manual

Additional information

14
Chapter 14
Additional information

Resetting the recorder

If you need to, you can reset the recorder to all its factory
settings.
1 Make sure that the recorder is on.
2 Press and hold
ON.
The recorder turns off with all settings reset.
Setting up the remote to control your
TV
You can use the supplied remote to control your TV. To be
able to use this feature you first have to program the
remote with a maker code from the table below.
1 Press and hold down the CLEAR button, then
enter the maker code for your TV.
The LED indicator on the remote controls lights.
See the table below for the list of maker codes. If there is
more than one code given for your make, input the first
one in the list.
• If the maker's name of your TV doesn't appear in the
table below, you will not be able to use this remote to
control your TV.
2 Press TV to check that the remote works with
your TV.
If the remote is set up correctly, the TV should switch on/
off. If it doesn't and there is another code given for your
maker, repeat step 1 with a new code.
Using the TV remote control buttons
The table below shows how to use this remote control
with your TV.
Button
TV
INPUT SELECT
TV VOLUME
TV CHANNEL
106
En
STOP and press STANDBY/
What it does
Press to switch the TV on/off (standby)
Press to change the TV's video input
Use to adjust the TV volume
Use to change TV channels
Maker Code
Aiwa 38
Funai 36
GE 11, 28
General 34
Goldstar 10, 23
Grandiente 30
Hitachi 06, 24, 25, 32
Magnavox 12, 29
Mitsubishi 09
NEC 37
Panasonic 08, 22, 41
Philips 07
Pioneer 00, 35, 40, 44
RCA 01, 15, 16, 17, 18
Sanyo 14, 21
Sharp 02, 19, 27
Sony 04
Toshiba 05, 26, 31, 43
Victor 13, 33, 42
Zenith 03, 20