Gas Engine Manual Transmission; Gas Engine Automatic Transmission - Cushman 84044 Maintenance Manual

6.24 GAS ENGINE MANUAL TRANSMISSION _______________________________________

The transmission fluid should be checked every 100
hours or 3 months. Fluid should be changed every 600
hours (or yearly).
Differential Fluid Capacity ...... 1.3 qts (1.2 l)
Fluid Type .............................. SAE EP 80-90 Gear Lube
To check transmission fluid level, remove the filler plug
from the front of the transmission. Fluid should be level
with the bottom of filler hole.
If fluid is low, add gear lube until fluid begins to leak from
hole. Apply pipe thread sealant and install filler plug.
To change fluid, remove drain plug from rear of
transmission.
Allow fluid to drain into a suitable container. Dispose of
used fluid properly according to local and state
regulations.
Apply pipe thread sealer to drain plug and install.

6.25 GAS ENGINE AUTOMATIC TRANSMISSION ____________________________________

The transmission fluid should be checked every 100
hours or 3 months. Fluid should be changed every 600
hours (or yearly).
Differential Fluid Capacity ...... 3.7 qts (4.2 l)
Fluid Type .............................. Mercon / Dexron II
To check transmission fluid level, the engine must be
running. Place the gear selector in "P" PARK, apply the
parking brake and start the engine.
With engine running, remove the dipstick and wipe it with
a clean rag. Insert the dipstick into the extension tube
until it contacts the tube. Remove the dipstick and read
the fluid level.
Fluid must be kept between the two marks on the
dipstick. If fluid is low, add fluid to obtain the proper level.
Do Not Overfill. Add fluid using the extension tube as a
fill tube.
To change fluid, remove drain plug from bottom of
transmission.
Allow fluid to drain into a suitable container. Dispose of
used fluid properly according to local and state
regulations.
Apply pipe thread sealer to drain plug and install.
Fill transmission until fluid reaches proper mark on
dipstick.
MAINTENANCE
Fill transmission with gear lube until fluid begins to leak
from hole. Apply pipe thread sealant and install filler plug.
Fill Plug
Transmission
Fluid Dipstick
and Fill Tube
Drain Plug
Automatic Transmission
6
Drain
Plug
Figure 6Q
Figure 6R
GB-27