Start Timing Under Synchronized Playback (With Several Players) - Pioneer V8000 Command Reference Manual

4.8

Start Timing Under Synchronized Playback (with several players)

To synchronize each playback to External Reference Sync Signal among several
players, issue the PL command after all players have finished the Search. The
next chart indicates the when to issue the PL command.
SE <CR>
When the player executes a Search (SE command) and it returns a completion
message, there is a brief period when the player ignores a PL command. Issue a
PL command at least 300ms after the command completion.
After issuing a PL command, there may be a brief period before synchronized
playback starts. If all players receive a PL command after a Search but before
the PLAY command is issued (see following example), then playback is
synchronized after a pause of approximately four fields which is less than one
Frame in length.
When the player receives a PL command during the Unspecified Area (see
below), the playback might start at the timing A field, or it might start at the timing
B. Thus, this playback location is called an Unspecified Area.
Only the PL command under external synchronization, is executed during the V
sync timing.
Example:
Ext.Sync.
field condition
Unspecified
area, 7msec
The video output under external synchronization delays for one field to the black
burst signal input to EXT SYNC IN terminal. In the above figure, the field of black
burst at the playback start timing is second field, but the field of the video output
from DVD-V8000 is first field.
2nd field
1st field
Waits PLAY
command
- 14
R<CR>
> 300 msec
B
4 fields
Operating Modes
PL<CR>
A
Playback
start