Removing And Replacing The Flip Assembly Bezel - Motorola V360 Service Manual

Disassembly

Removing and Replacing the Flip Assembly Bezel

30
1. Remove the battery cover, battery, SIM, antenna, rear housing, transceiver
board assembly, and flip assembly as described in the procedures.
2. Insert the disassembly tool into the openings on the flip bezel to pry up the flip
bezel.
3. Slide the edge of the disassembly tool along the sides of the flip bezel to release
the bezel snaps. Be careful not to damage the flip bezel (see Figure 11).
Flip Bezel
Figure 11. Removing the Flip Bezel
4. To replace, align the flip bezel to the flip assembly. Gently press the bezel onto
the flip assembly until all the snaps have engaged and the bezel is properly
seated on the flip assembly.
5. Replace the flip assembly, transceiver board assembly, rear housing, SIM,
battery, and battery cover as described in the procedures.
May 18, 2005
Disassembly
Tool
6809493A69-O
V360
050347o